C Variety Flex-Flex Couplings
The C Form coupling consists of two flex hubs, a single sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Type coupling consist of one particular flex hub, 1 rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Capabilities
Straightforward and reasonably priced variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Out there as vertical and horizontal couplings
Broad variety of particular variations for instance full-flex, flex-rigid mill motor
Conventional configurations can be found of the shelf
Ordering Data
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque necessity.
Speed: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Facts
Puller Holes are common on sizes four by way of twelve.
Puller Holes are available for sizes 7/8 by way of three.five at an additional charge.
The BSE (distance Among Shaft Ends) may well differ amongst G and G1.
Interference bores without any set screws are 
conventional unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Section.
Greater sizes are available, please talk to Technical Help.
C and CFR Type Effectiveness Data
Tags: