SMR Gearbox Set up
Satisfactory effectiveness is dependent upon right set up. lubrication and maintenance. therefore it’s important that the directions from the set up and upkeep leaflet. supplied with each gearbox. are followed very carefully. some of the important elements of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as shut on the reducer feasible, and mount reducer on driven shaft as shut to bearing as sensible. failure to complete this will likely trigger extra loads during the input shaft bearings and output bearings and could result in their premature failure.
two. Install motor and wedge belt drive with the belt pull at approximately 90° for the center line among driven and input shafts. this will likely permit tensioning with the wedge belt drive with all the torque arm which must ideally be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the appropriate.
3. lnstall torque-arm fulcrum on the rigid support so that the torque-arm is going to be at about correct angles on the center line with the driven shaft as well as torque arm situation bolt. make certain there is certainly enough consider up while in the turnbuckle for belt tension adjustment.
Keep close.
Bell drive may very well be located in any convenient postion. in the event the torque arm is always to be utilised to tighten the belts, the drive needs to be at about tight angle to your 
line between the input and output shafts.
Bell drive may be positioned towards the proper if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that proven while in the illustration.
Torque arm and belt take up.
Torque arm could possibly be mounted to the right if wanted.
SMR Gearbox Set up
Tags: