Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is developed exclusively to the little lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be widely utilized in the market of logistic devices for example minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed from the solenoid valve with all the speed controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This power unit is made solely for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the speed controlled by the adjustable needle valve. When the lift rises to a high positoin, but the power provide is cut, the lowering movement is controlled by the manual override perform.
Power UNITS FOR LIFT TABLE three
Basic Description
This energy unit is designed solely for your big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the speed managed by a strain compensated movement handle valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This power unit is made exclusively for your large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve plus the velocity managed by the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power provide is cut, the reducing movement is managed through the guide override perform.
Special Notes
1. This power unit is of S3 duty cycle, which might only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic elements concerned prior to installation of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which must also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil transforming is required after the original a hundred operation hours,afterwards the moment every single 3000 hours.
five. The electrical power unit proven is intended to be mounted vertically.