Stainless Steel Gear Rack

A Equipment Rack or Rack Equipment consists of spur gear tooth or helical gear the teeth cut on a linear rectangular or round rod. Both round equipment racks and linear gear racks serves as a a sector gear with an Stainless Steel Gear Rack china infinitely huge radius of curvature.

The most obvious use of a spur gear rack is to convert the rotary motion of a pinion gear into linear motion or vise versa. When assembled, they are known as a rack and pinion. Rack gears provide an benefit over ball screws because they have a huge load carrying ability and a straightforward design which allows linking multiple racks to meet your required length.
We carry both rectangular and circular cross-section gear rack styles in a
selection of precision pitches. All our inch and metric gear racks possess machined ends for applications needing the use of multiple gear racks in a string.
Whenever your machine’s precision movement drive exceeds what can simply and economically be achieved via ball screws, rack and pinion is the logical choice. Best of all, our gear rack comes with indexing holes and mounting holes pre-bored. That saves you lots of time, hassle and expenditure.

If your travel length is more than can be obtained from a single length of rack, no issue. Precision machined ends enable you to butt extra pieces and keep on going.
A rack can be called equipment rack or just railing. They are rectangular designed rods that are provided on one part with toothing as being a gear. By utilizing a gear that partcipates in the toothing of the rack, it is possible to move the gear or the rack longitudinally. Tooth racks are utilized, among other activities, in machines where a rotational motion should be converted to an easy movement or vice versa.

If power transmitting is carried out by equipment coupling, module transmission must be used. Usually the module identifies the type of the gear and it is the ratio between pitch and p. Module changes according to the pitch. Here following a conversion table.
The current industry standard, these 20° pressure angle gears have thicker, stronger teeth than 14½° pressure angle gears. Compared to plastic-type gears and racks, they’re better for high-load, high-speed, and durable applications. Also known as spur gears.


Find Us

SSJ Timing Pulley Co., Ltd.

Mail: [email protected]

As one of leading manufacturers, suppliers and exporters of mechanical products in China, We offer reducers, sprockets, industrial and conveyor chain, belts, pulleys, gears, racks, gearboxes, motors, PTO Shafts, taper lock Bushing, vacuum Pumps, screw air compressors and many other products. Please contact us for details.

Recent Posts